Translator and MAF problems

B

BiggRivv

Member
I installed the Gen II and LT1 Maf sensor per instructions, reset the ECM and the car was hard to start, I got it started and drove about 15 miles, the car drove great, I got back to the house shut it off and went to start it 2 minutes later and nothing no crank at all, totally dead, checked battery 13 volts, do you have any ideas what could be the problem?
Thanks
 
EricM

EricM

Administrator
Staff member
That would have nothing to do with the Translator. The MAF system is not used for starting/cranking.

Maybe some other wiring got disturbed or disconnected during the install?
 
You must log in or register to reply here.
Top