I just got my Scanmaster G the other day.. tried to install it today. I connected to pin 7 on powerlogger input board. I flashed the powerlogger module with the latest software. Still no communication. The scanmaster G option is checked off in the powerlogger software. I have been using the normal powerlogger software for over a month and it's been working fine. I don't want to have to drag the laptop with me and my USB on my computer is getting worn out. Any help would be greatly appreciated. Thanks!
Scanmaster G with powerlogger says No Data
- Thread starter JimsGN22
- Start date
If it's that new, then it should be fine.
It really sounds like a bad connection between the scanmaster and powerlogger. I would double check that the beige cable is fully seated in both the PL input module and the powerlogger board, and make sure the wire connected to terminal 7 is making good contact.
Also double check that the Scanmaster G option stayed on.
If all that is good, then I'll have to check it out here.
It really sounds like a bad connection between the scanmaster and powerlogger. I would double check that the beige cable is fully seated in both the PL input module and the powerlogger board, and make sure the wire connected to terminal 7 is making good contact.
Also double check that the Scanmaster G option stayed on.
If all that is good, then I'll have to check it out here.
It is selected scanmaster G in powerlogger. I have been using the powerlogger without any hiccups. Just no communication through the direct connection. I have a 3 bar map sensor connected to the direct connection module and it works perfectly. I'm not sure if I can get back to the car for 3 weeks. I have a crazy busy schedule.