Thanks Eric, it was the case I was asking about. I had the top and bottom of the case figured out, I was just which way the board went when putting it back together. Does the side of the board with chips face the top of the case or the bottom of the case?For the case itself, the screw heads are on the bottom.
Thank you Eric, as it turns out I have the chips facing the top. At worst the data would have been displayed upside down.The chips face the bottom.
Mine is a red display. The ScanMaster was in my car when I bought it in 2008, so it is rather old.Is yours a red display? It may be different between the blue and red ones. I looked at a blue one.
Thank you turbobob. I took mine apart and didn't pay attention and when I went to put it back together I was bit puzzled. I am not sure how old the ScanMaster is that I am selling, it was in the car when I bought it in 2008. I have never had any issues with it though. Back in 2010 when I purchased the PL setup, I contacted you and then sent my SM to you and it came back with the updated 2.2 chip. It was free of charge, other than the shipping. If memory serves I believe you covered the shipping charges when you returned it to me.chips face down on all scanmasters.