Chip Instructions for the 6.0 and 6.1 wideband Chip

J

JW87T

Well-Known Member
Eric,
I notice that the 6.0 instructions now state the default values for the AF values as 'Varies'.

Why is that? Does it vary with the type of WBo2? The original instructions I got said the AF defaults were 10.8/10.8/11.5 for
1-2/3-4/mid-boost. Is that correct for my setup with PLX wb?

Thanks.
..Jack W.
 
EricM

EricM

Administrator
Staff member
Some people asked for different default settings, some also default to off (9.9). Whatever yours is when you reset the ECM is the default. I didn't want to make difference instructions for each chip, so I changed it to "varies" in the instructions. I should probably say "varies by chip".
 
J

JW87T

Well-Known Member
OK, thanks. I am guessing my chip's defaults are the ones you originally documented since I haven't changed them.

One more question: there was a thread with a question about how much people have to increase fueling because of cold weather. With the 6.0, do you even have to worry about that? Cold air means more air going in which should cause the 6.0 chip to increase fueling to compensate to maintain the target AFR, right?

...Jack.
 
EricM

EricM

Administrator
Staff member
Yep, it will add fuel on its own to maintain the target air/fuel ratio.
 
EricM

EricM

Administrator
Staff member
Updated the instructions to clarify some things. (same link from the 1st post)

Eric
 
M

MNwe4

Well-Known Member
6.0 updates?

Eric, just browsing the forums. Does the 6.1 WB update also include the closed loop idle option like the 5.7 update? Keep up the good work!
 
Last edited:
EricM

EricM

Administrator
Staff member
The 6.1 adds the capability to change the parameters in the powerlogger software, in addition to using the gas-pedal method.
 
You must log in or register to reply here.
Top