Wideband O2 Harness Connector (ECU-GN Port)

MCH86GN

MCH86GN

Active Member
I just need to know what connector is used on the WB O2 harness that plugs into the ECU-GN port? I need to de-pin it, but I don't know what connector is used therefore I don't know what tool to get to de-pin it. I searched the forum and online, but I couldn't seem to find any information on ECU-GN side WB O2 connector.
 
T

TurboBob

Well-Known Member
the connector is a TE 794954-6
the pins are TE 1586315-3
the depinning tool is TE 1586343-1 although there is a Molex tool that is cheaper
 
MCH86GN

MCH86GN

Active Member
TurboBob said:
the connector is a TE 794954-6
the pins are TE 1586315-3
the depinning tool is TE 1586343-1 although there is a Molex tool that is cheaper
Click to expand...
Hey Bob,

You've been loads of help. First sparkplug wires and now providing me an answer so I can get moving with the rest of my ECU-GN conversion.
 
MCH86GN

MCH86GN

Active Member
TurboBob said:
any time. This forum is a good place for questions like this. FB buries this sort of info.

Bob
Click to expand...
Hey Bob,

After trying to use stables and various other pieces of connectors to try and remove the connector, I finally gave in and went to Amazon and found the proper tool to remove the terminals. The search was made much easier because I had the actual removal tool part number. It cost around $17 and it was delivered within 12 hours of me ordering it.


Below is the link.

71ie23rcp1L._AC_SX679_.jpg
 
You must log in or register to reply here.
Top